Buy New and Refurbished Network Equipment

Ceiling-mount indoor antenna with RP-TNC connector-This antenna was designed forWLAN applications with frequencies of 2400-2500 MHz. The antenna is omni directional and has a nominal gain of 5.2 dBi. It comes with a clip that allows it to be mounted to a drop-ceiling cross member.

High-gain outdoor directional antenna with a RP-TNC connector-This WLAN antenna is a completely enclosed 16-element yagi. It is designed to be used as a bridge antenna between two networks or for point-to-point communications. It has a nominal VSWR of1.5:1 and is less than 2:1 over the entire frequency band. The gain is 13.5 dBi and the half-power beamwidth is 30 degrees. This antenna is normally mounted on a mast and is vertically polarized.

Cisco 6.5 dBi with two radiating elements diversity patch wall mount Indoor/Outdoor, unobtrusive medium range antenna

2.4 GHz, 2 dBi Omni Ceiling Antenna w/ RP-TNC Connector

High-gain outdoor directional antenna with a RP-TNC connector-This WLAN antenna is a completely enclosed yagi. It is designed to be used as a bridge antenna between two networks or for point-to-point communications. It has a nominal VSWR of 1.5:1 and is less than 2:1 over the entire frequency band. The gain is 10 dBi and the half-power beamwidth is 55 degrees. This antenna is normally mounted on a mast and is vertically polarized.

Mast mount outdoor high gain antenna with a RP-TNC connector-This antenna was designed for WLAN applications for frequencies of 2400-2500 MHz. The antenna is omni directional and has a nominal gain of 12 dBi. This design uses an elevated center-feed to produce an elevation pattern with very little "squint" or beam-tilt. It is designed to be mounted on a round mast.

Mast mount outdoor sector antenna with a RP-TNC connector-This antenna was designed for WLAN applications for frequencies of 2400-2500 MHz. The antenna is directional and has a nominal gain of 14 dBi. Its flexible mounting bracket allows for either mast or wall mounting options.

This antenna is compatible with any 2.4-GHz Cisco Aironet device with an RP-TNC plug. The antenna has an articulated base that can be rotated 360 degrees at the connection point and from 0 to 90 degrees at its knuckle.

Single gray dipole antenna with an RP-TNC connector. The antenna provides indoor omnidirectional coverage and is designed for use in the 2400-2500 MHz frequency band. It does not articulate as the other dipole antennas. It can be used with all radios that utilize an RP-TNC antenna connector.

Single white dipole antenna with an RP-TNC connector. The antenna provides indoor omnidirectional coverage and is designed for use in the 2400-2500 MHz frequency band. It has a 90-degree articulation radius. It can be used with all radios that utilize an RP-TNC antenna connector.

2.4 GHz 2.2 dBi Low Profile Monopole Antenna White, RP-TNC

Ceiling-mount indoor omni-directional antenna with three cables terminating in RP-TNC connectors. For use only with the 1250 Series Access Points. For use in the 2400-2500 MHz frequency band. The pigtail cables are plenum rated and 36" long each.

2.4 GHz 4 dBi 802.11n Omni wall mount antenna

2.4 GHz, 5 dBi, 135-degree Sector w/ RP-TNC Connector

2.4 GHz, 5 dBi omnidirectional antenna for mesh access points. Suitable for use on Cisco Aironet 1520 Series Mesh Access Points in all deployments including cable strand mounting situations. It mounts directily to the access point and has no cable attachments.

2.4 GHz 5 dBi Omni Antenna, N conn, HazLoc

2.4 GHz 2.5dBi/5 GHz 3.5dBi 802.11n Omni Antenna, RP-TNC

Ceiling Mount Omni-directional Antenna-Designed for use indoor, this antenna comes with ceiling mount hardware. It has 4 plenum rated pigtail cables, 18 inches each, with 4 right angle RP-TNC connectors.

A 5.5 dBi antenna for use in the 2400-2484 MHz frequency band which utilizes aN-type connector. This antenna directly mounts onto the unit, and has no cable attachments.

2.4 GHz 6 dBi 802.11n directional antenna

Wall mount, indoor/outdoor directional patch antenna. Designed for use with any radio that features an RP-TNC antenna connector. For use in the 2400-2500 MHz frequency band. The pigtail cable is plenum rated, 36" long.

Wall-mount indoor/outdoor antenna with two RP-TNC connectors-Similar to the above patch, but providing diversity antennas in the same package for areas where multipath problems exist. The pigtail cable is plenum rated and 36" long.

2.4 GHz, 8 dBi omnidirectional antenna for use in the 2400 - 2484 MHz frequency band which utilizes an N-type connector. It mounts directly to the access point and has no cable attachments

Wall mount indoor/outdoor antenna with a RP-TNC connector-Designed for use with any radio that features a RP-TNC connector. For use in the 2400-2500 MHz frequency band. The plenum rated pigtail cable is 36" long.

Mast-mount indoor/outdoor antenna with a RP-TNC connector-This antenna was designed for WLAN applications for frequencies of 2400-2500 MHz. The antenna is omnidirectional and has a nominal gain of 5.2 dBi. It is designed to be mounted on a round mast.

2.4 GHz 13 dBi/5 GHz 7 dBi 11n Dual Band Patch Ant., Qty 4

2.4 GHz 2 dBi/5 GHz 4 dBi Dipole Ant., Blk, RP-TNC

2.4 GHz 2 dBi/5 GHz 4 dBi Dipole Ant., Gray, RP-TNC

2.4 GHz 2 dBi/5 GHz 4 dBi Dipole Ant., White, RP-TNC

2.4GHz 2dBi/5GHz 4dBi Ceiling Mount Omni Ant., 4-port,RP-TNC

2.4GHz 4dBi/5GHz 4dBi Multi Mount Omni Ant., 4-port,RP-TNC

2.4 GHz 4dBi/5 GHz 7dBi Dual Band Omni Antenna, N connector

2.4 GHz 4dBi/5 GHz 7dBi Dual Band Omni Ant, N conn, HazLoc

2.4 GHz 6 dBi/5 GHz 6 dBi Directional Ant., 4-port, RP-TNC

2.4 GHz 8 dBi/5 GHz 8 dBi Directional Ant., 3 port, N conn.