Cisco Wireless Antennas

Cisco Wireless Antennas - Aironet Antennas, Yagis & 3G

Every wireless Local Area Network (LAN) deployment is different. When engineering an in-building solution, varying facility sizes, construction materials, and interior divisions raise a host of transmission and multipath considerations. When implementing a building-to-building solution, distance, physical obstructions between facilities, and number of transmission points involved must be accounted for. With directional and omnidirectional antennas, low-loss cable, mounting hardware, and other accessories, installers can customize a wireless solution that meets the requirements of even the most challenging applications.

POA

AIR-ANT1728

Ceiling-mount indoor antenna with RP-TNC connector-This antenna was designed forWLAN applications with frequencies of 2400-2500 MHz. The antenna is omni directional and has a nominal gain of 5.2 dBi. It comes with a clip that allows it to be mounted to a drop-ceiling cross member.

3-5 days. POA

POA

AIR-ANT1729

Cisco 6 dBi Patch Wall Mount Antenna. Indoor, unobtrusive long-range antenna (may also be used as a medium-range bridge antenna)

3-5 days. POA

POA

AIR-ANT1949

High-gain outdoor directional antenna with a RP-TNC connector-This WLAN antenna is a completely enclosed 16-element yagi. It is designed to be used as a bridge antenna between two networks or for point-to-point communications. It has a nominal VSWR of1.5:1 and is less than 2:1 over the entire frequency band. The gain is 13.5 dBi and the half-power beamwidth is 30 degrees. This antenna is normally mounted on a mast and is vertically polarized.

3-5 days. POA

AU$ 25.00

AIR-ANT2012

Cisco 6.5 dBi with two radiating elements diversity patch wall mount Indoor/Outdoor, unobtrusive medium range antenna

3-5 days

POA

AIR-ANT2410Y-R

High-gain outdoor directional antenna with a RP-TNC connector-This WLAN antenna is a completely enclosed yagi. It is designed to be used as a bridge antenna between two networks or for point-to-point communications. It has a nominal VSWR of 1.5:1 and is less than 2:1 over the entire frequency band. The gain is 10 dBi and the half-power beamwidth is 55 degrees. This antenna is normally mounted on a mast and is vertically polarized.

3-5 days. POA

POA

AIR-ANT24120

Mast mount outdoor high gain antenna with a RP-TNC connector-This antenna was designed for WLAN applications for frequencies of 2400-2500 MHz. The antenna is omni directional and has a nominal gain of 12 dBi. This design uses an elevated center-feed to produce an elevation pattern with very little "squint" or beam-tilt. It is designed to be mounted on a round mast.

3-5 days. POA

POA

AIR-ANT2414S-R

Mast mount outdoor sector antenna with a RP-TNC connector-This antenna was designed for WLAN applications for frequencies of 2400-2500 MHz. The antenna is directional and has a nominal gain of 14 dBi. Its flexible mounting bracket allows for either mast or wall mounting options.

3-5 days. POA

POA

AIR-ANT2422DB-R

This antenna is compatible with any 2.4-GHz Cisco Aironet device with an RP-TNC plug. The antenna has an articulated base that can be rotated 360 degrees at the connection point and from 0 to 90 degrees at its knuckle.

3-5 days. POA

AU$ 16.00

AIR-ANT2422DG-R

Single gray dipole antenna with an RP-TNC connector. The antenna provides indoor omnidirectional coverage and is designed for use in the 2400-2500 MHz frequency band. It does not articulate as the other dipole antennas. It can be used with all radios that utilize an RP-TNC antenna connector.

24 hrs

POA

AIR-ANT2422DW-R

Single white dipole antenna with an RP-TNC connector. The antenna provides indoor omnidirectional coverage and is designed for use in the 2400-2500 MHz frequency band. It has a 90-degree articulation radius. It can be used with all radios that utilize an RP-TNC antenna connector.

3-5 days. POA

POA

AIR-ANT2430V-R

Ceiling-mount indoor omni-directional antenna with three cables terminating in RP-TNC connectors. For use only with the 1250 Series Access Points. For use in the 2400-2500 MHz frequency band. The pigtail cables are plenum rated and 36" long each.

3-5 days. POA

POA

AIR-ANT2450V-N

2.4 GHz, 5 dBi omnidirectional antenna for mesh access points. Suitable for use on Cisco Aironet 1520 Series Mesh Access Points in all deployments including cable strand mounting situations. It mounts directily to the access point and has no cable attachments.

3-5 days. POA

POA

AIR-ANT2451V-R

Ceiling Mount Omni-directional Antenna-Designed for use indoor, this antenna comes with ceiling mount hardware. It has 4 plenum rated pigtail cables, 18 inches each, with 4 right angle RP-TNC connectors.

3-5 days. POA

POA

AIR-ANT2455V-N

A 5.5 dBi antenna for use in the 2400-2484 MHz frequency band which utilizes aN-type connector. This antenna directly mounts onto the unit, and has no cable attachments.

3-5 days. POA

POA

AIR-ANT2460P-R

Wall mount, indoor/outdoor directional patch antenna. Designed for use with any radio that features an RP-TNC antenna connector. For use in the 2400-2500 MHz frequency band. The pigtail cable is plenum rated, 36" long.

3-5 days. POA

AU$ 220.00

AIR-ANT2465P-R

Wall-mount indoor/outdoor antenna with two RP-TNC connectors-Similar to the above patch, but providing diversity antennas in the same package for areas where multipath problems exist. The pigtail cable is plenum rated and 36" long.

24 hrs

POA

AIR-ANT2480V-N

2.4 GHz, 8 dBi omnidirectional antenna for use in the 2400 - 2484 MHz frequency band which utilizes an N-type connector. It mounts directly to the access point and has no cable attachments

3-5 days. POA

POA

AIR-ANT2485P-R

Wall mount indoor/outdoor antenna with a RP-TNC connector-Designed for use with any radio that features a RP-TNC connector. For use in the 2400-2500 MHz frequency band. The plenum rated pigtail cable is 36" long.

3-5 days. POA

POA

AIR-ANT2506

Mast-mount indoor/outdoor antenna with a RP-TNC connector-This antenna was designed for WLAN applications for frequencies of 2400-2500 MHz. The antenna is omnidirectional and has a nominal gain of 5.2 dBi. It is designed to be mounted on a round mast.

3-5 days. POA

POA

AIR-ANT3213

Pillar-mount diversity, indoor antenna with two RP-TNC connectors-Cosmetic antenna is ideal for the retail or hospital environment. Includes 36 in. of white RG-58 cable with a separation of coaxial cables that are joined together to form a 10 in. length. Has a tan cloth covering in a 14 in. x 5 in. x 1 in. rectangle. Included are two mounting brackets that will keep the antenna 6 in. off the wall.

3-5 days. POA

POA

AIR-ANT3338

Very high-gain outdoor antenna with a RP-TNC connector-This WLAN antenna is aparabolic dish designed to be used as a bridge antenna between two networks or for point-to-point communications. It consists of an aluminum parabolic reflector and feed antenna. The antenna features a rugged mount. It also offers 20 degree fine adjustment for both horizontal and vertical planes. The antenna is provided with hardware for mast mounting.

3-5 days. POA

AU$ 30.00

AIR-ANT3549

Cisco 8.5 dBi Hemispherical Patch Antenna. Indoor, unobtrusive long-range antenna (may also be used as a medium-range bridge antenna)

24 hrs

POA

AIR-ANT4121

Cisco 12 dBi Omnidirectional Mast Mount Antenna. Outdoor short-range point-to-multipoint applications.

3-5 days. POA

AU$ 16.00

AIR-ANT4941

Single black dipole antenna with an RP-TNC connector. The antenna provides indoor omnidirectional coverage and is designed for use in the 2400-2500 MHz frequency band. It has a 90-degree articulation radius. It can be used with all radios that utilize an RP-TNC antenna connector.

24 hrs

POA

AIR-ANT5114P-N

5 GHz, 14 dBi patch antenna for use in the 4950-5850MHz frequency band. The antenna has an N-type connector, and will require a separate low loss cable for mounting to the access point. Articulating mount included. Fits mast pole sizes 2" diameter maximum

3-5 days. POA

POA

AIR-ANT5117S-N

5 GHz, 17 dBi sector antenna for use in the 4950-5850MHz frequency band. The antenna has an N-type connector, and will require a separate low loss cable for mounting to the access point. Fits mast pole sizes 1.5 to 3" diameter maximum.

3-5 days. POA

AU$ 18.90

AIR-ANT5135D-R

Indoor-only black dipole like omnidirectional antenna for 5 GHz. Used with the 802.11a radio (AIR-RM22A) and the 1200 Series access point.

24 hrs

POA

AIR-ANT5135DB-R

The antenna operates in the 5-GHz frequency band and is designed for use with Cisco Aironet 5-GHz radio products using a reverse-polarity Neil Councilman connector (RP-TNC).

3-5 days. POA

POA

AIR-ANT5135DG-R

Indoor-only gray, non-articulating dipole like omnidirectional antenna for 5 GHz. Use with any radio with 5 GHz connectors.

3-5 days. POA

POA

AIR-ANT5135DW-R

Indoor-only white dipole like omnidirectional antenna for 5 GHz. Used with the 802.11a radio (AIR-RM22A) and the 1200 Series access point.

3-5 days. POA

Your Shopping cart is empty.

Category Navigation:

You're currently on: